/*--------------------------------------------------------------*/
/* Operational MODE Data Acquisition Programing Sample			*/
/* Single Buffer Version										*/
/* Big Endian, 32bit(VME Double Word Access)					*/
/* Draft Revision 1.0a.............June 29, 2005 HIRAYAMA		*/
/*-------------													*/
/* VME_BASE : VME_BASE address (Default 0x800000)				*/
/* DPtop : Dual Port Memory top Address(VME_BASE+$60000+$11F00)	*/
/* Pcnt  : Pcounter												*/
/* RunS  : Run Status											*/
/* TRC   : Time range count										*/
/* Mid   : Module ID											*/
/* CE00  : CH_Enable(#31(MSB)-#00(LSB))							*/
/* CE32  : CH_Enable(#63(MSB)-#32(LSB))							*/
/* Num   : Number of partitions									*/
/* Icnt  : Icounter												*/
/* Scnt  : Scounter												*/
/* RecDB : Recording data buffer								*/
/*--------------------------------------------------------------*/

typedef unsigned long  DWORD;
typedef DWORD  * DWORDP;
/*RunStatus*/
struct sample {
	unsigned : 1;					/* Not Use */
	unsigned start_me: 1;			/* start mesurement */
	unsigned common_mode: 1;		/* common start/stop */
	unsigned edge_detect: 2;		/* edge detection */
	unsigned sub_offset: 2;			/* subtract offset */
	unsigned mesure_cont: 1;		/* mesrement control */
	unsigned :20;					/* Not Use */
	unsigned width_sele: 3;			/* width select */
	unsigned : 1;					/* Not Use */
};
union  {
	unsigned long int uliRUN_Data;
	struct sample RUN_Bits;
} RUN_Format;

DWORDP Pcnt, RunS, TRC, Mid, CE00, CE32, Icnt. Scnt, RecDB, ReadAddr, WriteAddr;
DPtop = VME_Base + 0x60000 + 0x11F00;
Pcnt = (DWORDP) (DPtop);
RunS = (DWORDP) (DPtop + 0x4);
TRC = (DWORDP) (DPtop + 0x08);
Mid = (DWORDP) (DPtop + 0x0c);
CE00 = (DWORDP) (DPtop + 0x10);
CE32 = (DWORDP) (DPtop + 0x14);
Num = (DWORDP) (DPtop + 0x018);
Icnt = (DWORDP) (DPtop + 0x01c);
Scnt = (DWORDP) (DPtop + 0x0e8);
RecDB = (DWORDP) (DPtop + 0x0100);
/*!!!! Please fill "XXXXXX"  !!!!*/
WriteAddr = (DWORDP)(XXXXXX);	/* WriteAddr is destination of save data address */




/*----Setting Run Status Parameter----*/
RUN_Format.uliRUN_Data=0;
RUN_Format.RUN_Bits.common_mode=0x0;		/* Set "common start mode" */
RUN_Format.RUN_Bits.edge_detect=0x0;		/* Set rising */
RUN_Format.RUN_Bits.sub_offset=0x0;			/* no offset */
RUN_Format.RUN_Bits.mesure_cont=0x0;		/* TRG mode */
RUN_Format.RUN_Bits.width_sele=0x0;			/* width resolution 0.78125ns */


*TRC = 0x7ea;								/* Time Range Count setting about 50us */
*Mid = 0x0;									/* Module ID=0   */
*CE00 = 0x0FFFFFFFF;						/* all CH enable */
*CE32 = 0x0FFFFFFFF;						/* all CH enable */
*Num = 0x01;								/* Number of partitions=1 Single Buffer */

/*----Prepare for start measurement----*/
RUN_Format.RUN_Bits.start_me=0x1;			/* start measurement(Run Status)=1 */
*RunS = RUN_Format.uliRUN_Data;
(*Pcnt)++;									/* Pcount++ update Pcount */


/*----Start Measurement----*/
while(1){
	/*--Input Data--*/
	DataInput();

	while(*Scnt == *Icnt){						/* waiting until Scounter not equal Icounter */
		if( KeyHit() ){
			RUN_Format.RUN_Bits.start_me=0;				/* start mesurement=0 */
			break;
		}
	}
	if(RUN_Format.RUN_Bits.start_me==0){
		break;
	}

	/*----Read Hit Data----*/
	ReadAddr = (DWORDP) (RecDB);				/* Start address of read data */
	do{
		*WriteAddr++ = *ReadAddr++;					/* saving data */
	}while((*ReadAddr&0x0ffff0000)!=0x55550000 );/* if "end of data" value, reading data finish */

	*Icnt=*Scnt;
}
/*----quit of measurement----*/
*RunS = RUN_Format.uliRUN_Data;